100 μL from each well were plated onto TS agar and incubated overnight at 37°C. For the invasion assay, the monolayer selleck products was washed three times with DPBS. Two millilitres of cell culture medium supplemented with 1% antibiotic/antimycotic solution and 100 μg/mL gentamicin (Gibco) were added to each well. The 6-well

plates were incubated for another 2 h at 37°C and 5% CO2 to kill extracellular and surface-adherent bacteria. Afterwards, the monolayers were washed three times with DPBS and bacteria were quantified as described for the adherence assay. Assays were performed in duplicate and repeated twice. For comparative reasons, isolate 21702 was used as an internal assay control in every assay. Antibiotic efficacy buy Temsirolimus of the invasion assay was tested for all strains with concentrations of 107 CFU/mL in pure cell culture medium, confirming that no viable bacteria were present after 2 h incubation (data not shown). Mechanical stretch Cultures of EA.hy926 were subjected

to cyclic tension using a FlexCell vacuum system (FlexCell, Dunn Laboratories, Hillsborough, USA). Cells were cultured on BioFlex culture plates (FlexCell) coated with collagen I in a humidified atmosphere with 5% CO2 at 37°C for 72 h. Afterwards cultures were stretched by 10% with a frequency of 1 Hz in a square wave pattern for another 24 h. EA.hy926 from the same preparation and cultured without mechanical Cytidine deaminase stretch were used as controls. Stretched cells and controls were infected immediately after completion of mechanical stretch as described above. Biofilm assay The biofilm assay used in this study was performed as described previously [30] with the following modifications: absorbance was measured using the GENios Plate Reader (Tecan Deutschland GmbH, Crailsheim, Germany) at 450 nm (total bacterial growth) and 550 nm (crystal violet (CV), biofilm formation). Each strain was MK-0457 nmr assayed in quintuplicate. ECM assay

96 well microtiter plates were coated with 10 μg/mL fibrinogen (human plasma, Sigma). Microtiter plates precoated with collagen I, collagen II, collagen IV, fibronectin, laminin, tenascin and vitronectin were purchased from Chemicon (Millipore, Schwalbach, Germany). Wells coated with BSA were used as negative controls and values were subtracted. Late-log-phase cultures of bacteria were inoculated into 100 μL BHI medium (Oxoid) and incubated on pre-coated wells without agitation for 2 h at 37°C. Subsequently, wells were washed twice with DPBS and dried for 20 min at 60°C. In parallel, bacteria were plated onto BHI agar and incubated overnight at 37°C. Attached bacteria were stained with 100 μL of 0.4% CV at room temperature for 45 min. Wells were rinsed five times with PBS and air dried. CV was solubilized in 100 μL ethanol (99%), and the absorbance was measured at 550 nm. Each strain was assayed in quadruplicate for the different ECM proteins.