Three chambers were used simultaneously (n = 3 for the CO2 response) in a system as described previously (Pons and Welschen 2002). They were connected to a temperature regulated water bath and could be alternately connected to an IRGA (Licor 6262, Lincoln, Nebraska, USA) for measuring the gas exchange rates. Light was provided by means of slide projectors with a halogen lamp.

The leaves were kept in the leaf chamber at saturating irradiance as derived from irradiance response curves (1,000 and 300 μmol photons m−2 s−1 for HL- and LL-plants, respectively) and ambient [CO2] Trichostatin A purchase until steady state gas exchange rates were achieved (at least 30 min). Selonsertib research buy Thereafter the CO2 response was measured from low to high [CO2] LCZ696 supplier with three CO2 concentrations below ambient and three above. Measurements were done with the leaf temperature set at the two growth temperatures (10 and 22 °C). The CO2 compensation point in the absence of respiration in the light (Γ*) was estimated at the two temperatures on Arabidopsis Col-0 plants grown at 20 °C using the Brooks and Farquhar (1985) method. Atmospheric pressure was 101.6 kPa on average.

The temperature dependence of net CO2 assimilation rates at ambient [CO2] (38 Pa) and at the growth and saturating irradiance (A growth and A sat, respectively) was measured in two Parkinson leaf chambers. The chambers were modified so that they could be connected to the same system as mentioned above (Pons and next Welschen 2002). The measurements were done twice with the two chambers (n = 4). The chamber with a circular window of 2.5 cm2

was used to simultaneously measure gas exchange and chlorophyll fluorescence (PAM-2000; Walz, Germany). Measurements were done at ambient [O2] (21 %) and low [O2] (1 %) in order to estimate the degree of limitation by TPU (Sage and Sharkey 1987). Gas exchange data for both chamber types were corrected for minor leakages using empty chamber values and in the case of the Parkinson chambers also for dark respiration of leaf parts clamped under the gasket (Pons and Welschen 2002). Structural and chemical analysis After the measurements leaf punches of 0.126 cm2 were sampled for measuring chlorophyll, two in the case of small leaves (<3 cm2) and four when leaves were larger. The remainder of the leaves from the CO2 response measurements was used for measuring Rubisco content. The remainder of the leaves from the temperature response measurements was used for determining LMA from leaf dry mass and area. Rubisco contents were measured as described previously (Westbeek et al. 1999; Mommer et al. 2005). The leaf extract was run on SDS-PAGE gels that were scanned. Custom-made image analysis was used to calculate Rubisco content from the large subunit. Chlorophyll was extracted in dimethylformamide (DMF) for at least 5 days in darkness. Contents were calculated using the formula provided by Inskeep and Bloom (1985).